Sharp AR-M237 Copier Manual page 204

WHEN AN ALARM SOUNDS AND A
WARNING MESSAGE IS DISPLAYED
Alarms and display messages alert you to the condition of the machine during operation. If one of the following
messages appears, respond as indicated in the table.
Message screen (Alarm)
(MAINTENANCE REQUIRED.)
PLEASE RETURN XX
ORIGINALS TO THE
DOCUMENT FEEDER, THEN
PRESS [START].
OPEN TRAY X AND ADD XXX
PAPER.
(TYPE: XXXXX)
REMOVE PAPER FROM THE
UPPER TRAY.
REMOVE PAPER FROM THE
TOP TRAY.
(TONER SUPPLY IS LOW.)
CHANGE THE TONER
CARTRIDGE.
THE MEMORY BECOMES
FULL. (Pg.No.XX)
SEND SCANNED DATA? OR
CANCEL THE JOB?
POLLING IS NOT POSSIBLE
WITH THE AVAILABLE
MEMORY.
MANUAL RECEIVE IS
DISABLED.
DUE TO OUT OF MEMORY.
CLOSE THE XXXXX COVER.
CLOSE THE DOCUMENT
FEEDER.
CALL FOR SERVICE.
CODE:XX XX.
86
Cause and solution
Maintenance is required.
→ Contact your dealer.
A misfeed occurred in the RSPF while the original was
being scanned.
→ Reload the indicated original pages.
Printing cannot take place because the machine is out
of suitable paper.
→ Add the indicated paper.
The job separator tray is full.
→ Remove the printed pages.
The top tray is full (when a finisher is installed).
→ Remove the printed pages.
Little toner remains in the toner cartridge.
→ Replace the toner cartridge.
The toner cartridge is out of toner and the received
document cannot be printed.
→ Replace the toner cartridge.
The memory became full while the original was being
scanned.
→ Send only the pages that were already scanned, or cancel
the entire transmission.
Polling is not possible because there is not enough
space in memory.
→ Try polling again after currently stored jobs are completed.
Manual reception was not possible because there was
not enough free space in memory.
→ Try manual reception again after currently stored jobs have
been completed.
The indicated cover is open.
→ Close the indicated cover.
The self-diagnosis function has activated and
automatically stopped operation. An error code appears
in xx-xx.
→ Turn off the power and then turn it back on. If the same
message still appears, contact your SHARP service center.
Page
-
-
operation manual for
copier
-
-
operation manual for
copier
15
33
-
-
-