Parts Of The Machine - Sharp AR-M237 Copier Manual

BEFORE USING THE FAX FEATURE

PARTS OF THE MACHINE

13
12
Exit area
1
The original exits here after transmission or
scanning into memory.
Document feeder tray
2
Place the original face-up in this tray for
transmission.(p.10)
Original guides
3
Adjust these guides to match the width of the
original.(p.10)
Document glass
4
Books and other originals that cannot be inserted
into the RSPF can be placed here.(p.10)
Operation panel (p.5)
5
Job separator tray
6
Received faxes are delivered to this tray. Fax
function lists are also delivered here after printing.
*The job separator tray cannot be used when a
finisher is installed. Also, the output tray can be
changed using a key operator program for the
copy function. See "OUTPUT TRAYS" in the key
operator's guide.
Center tray
7
The output tray for received faxes can be changed
to the center tray using the key operator programs
for the copy function.
6
11
1 2 3
10
Front cover
8
Open this cover to remove a misfeed. (See the
operation manual for copier.)
Paper trays
9
These hold the paper that is used for fax reception
and copying. Each tray holds approximately 500
sheets of paper. (See the operation manual for
copier.)
Power switch
10
Turns the power on and off.(p.3)
Speaker
11
The line can be heard through the speaker during
on-hook dialing, as well as the beep that signals
the completion of a fax transmission.
LINE jack
12
Insert the telephone line cord here.(p.3)
TEL jack
13
Connect an extension telephone here.(p.61)
For parts of the machine that are related to
Note
both faxing and copying (parts related to
removing misfeeds, loading paper, etc.), see
"PART NAMES AND FUNCTIONS" in the
operation manual for copier.
4
5
6
7
8
9