Sharp AR-M237 Copier Manual page 202

TROUBLESHOOTING
Information appearing in the TYPE/NOTE column
Information such as the type of transmission and type of error appears in the TYPE/NOTE column of the Transaction
Report. The following notes may appear.
Note
OK
G3
ECM
SG3
FW.
NO RESPONSE
BUSY
CANCEL
P. FAIL
MEMORY. FULL
LENGTH OVER
ORIG ERROR
PASSCODE# E
RX NO POLL
NO RX POLL
SA POL TX ERR
SA POLL ERR
NO SA POLLING
NO S ADD FUNC
S ADD TX FAIL
ERROR xx xxxx
84
The transaction was completed normally.
Communication took place in G3 mode.
Communication took place in G3 ECM mode.
Communication took place in Super G3 mode.
The received data was forwarded.
No response from the receiving party.
Transmission was not possible because the other party was already using the
line.
A transmission was canceled while in progress, or a stored transmission job
was canceled.
A power failure occurred during the transaction.
The memory became full during reception.
The transmitted document was over 59" long and therefore could not be
received.
Manual transmission was not successful because a jam occurred.
The connection was broken because the polling passcode was not correct.
The machine that was polled does not have a polling function.
The other machine refused the polling operation, or your machine broke the
connection when polled because no data was in polling memory.
The other machine refused an F-code polling operation.
Your machine broke the connection because the other machine specified an
F-code polling sub-address that does not exist in your machine.
F-code polling was attempted, however, the other machine did not have an
F-code polling memory box.
F-code transmission was attempted, however, the other machine does not
support F-code communication.
An F-code transmission was refused by the other machine because of an
incorrect sub-address or other reason.
The communication handshake signals or image signals were distorted due to
line conditions or other reasons, and communication was not successful.
Codes for use by service technicians. For more infomation, consult your
SHARP service center.
Explanation