Sharp AR-M237 Copier Manual page 38

CONVENIENT COPY FUNCTIONS
1
Place the originals in the RSPF or on
the document glass. (p.22, p.23)
Example: 5 sets of copies or 5 copies per page of 3
originals
Originals
2
Touch the [OUTPUT] key.
2-SIDED COPY
OUTPUT
3
Touch the [SORT] or [GROUP] key.
UPPER
OUTPUT
TRAY
SORT
CENTER
TRAY
GROUP
4
Touch the output tray that you wish to
use.
UPPER
TRAY
CENTER
TRAY
To enable the offset function (p.35), touch the
Note
[OFFSET] checkbox so that a checkmark
appears. To disable the offset function, touch
the [OFFSET] checkbox again to clear the
checkmark.
36
If originals are placed in
the RSPF, the sort
function is automatically
selected. (To disable this
function, see the "Key
operator's guide".)
The output tray can only
be selected when a job
separator or finisher is
installed.
5
Touch the [OK] key.
OK
OFFSET
6
Select the number of copies and any
other desired copy settings, and then
press the [START] key (
ACC.#-C
7
[When using the RSPF:]
Copying will start after all the originals are
scanned.
[When using the document glass:]
Replace the original with the next original and
press the [START] key (
until all originals have been scanned, and then
touch the [READ-END] key.
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
The copies are grouped as follows:
Sort
Copy
5 sets of copies
If the memory becomes full while scanning the
originals, "MEMORY IS FULL. PRESS [START] TO
BEGIN COPYING OR [CA] TO CANCEL." will appear.
To copy only the originals that have been scanned,
press the [START] key (
the [CLEAR ALL] key (
The number of originals that can be scanned
Note
into memory can be increased by increasing
the memory allocation in the key operator
programs, or by installing more memory.
(See the "Key operator's guide".)
).
). Repeat this step
READ-END
Group
Copy
5 copies per page
) . To cancel the job, press
).