Fax Send Settings; Auto Reduction Sending Setting - Sharp AR-M237 Copier Manual

IMAGE MEMORY PRINT SELECT
SETTING
This program is used to select the conditions for
including a copy of part of the first page of the
transmitted document on transaction reports.
Selections are [PRINT OUT ALL REPORT], [PRINT
OUT ERROR REPORT ONLY], and [NO PRINTED
REPORT]. This program is used in combination with
the "TRANSACTION REPORT PRINT SELECT
SETTING", and is not effective if transaction reports
are set to never print out.
The factory default setting is "PRINT OUT ERROR
REPORT ONLY".
REMOTE RECEPTION NUMBER
SETTING
(only when an extension phone is connected)
Fax reception can be activated from an extension
phone connected to the machine by entering a 1-digit
number and pressing [ ] twice on the phone's
keypad. This number is called the remote reception
number, and you can set it to any number from "0" to
"9".
The factory default setting is "5".
EXTERNAL TELEPHONE SETTING
(only when an extension phone is connected)
Enable this setting when an extension phone is
connected to the machine. If this setting is not
enabled, it will not be possible to use an extension
phone connected to the machine to manually receive
faxes or place/receive phone calls.
This program is initially enabled (factory default
setting).
DISTINCTIVE RING DETECTION
If multiple telephone numbers have been assigned to
your telephone line, the number called can be
identified by its ringing pattern. By using one number
for voice calls and another number for faxes, you can
tell which type of call you are receiving by the ringing
pattern. You can set your machine to automatically
receive faxes when your fax number is called by
setting the pattern that corresponds to your fax
number. Six selections are available.
This program is initially disabled (factory default
setting).
KEY OPERATOR PROGRAMS

FAX SEND SETTINGS

The fax transmission settings allow you to adjust
certain parameters for sending faxes to better suit your
needs.
The fax send settings are as follows:
G AUTO REDUCTION SENDING SETTING
G PRINTING PAGE NUMBER AT RECEIVER
G DATE/OWN NUMBER PRINT POSITION
SETTING
G ROTATION SENDING SETTING
G CALL TIMER AT MEMORY SENDING
G RECALL IN CASE OF LINE BUSY
G RECALL IN CASE OF COMMUNICATION
ERROR
G QUICK ON LINE SENDING
G DEFAULT SENDING MODE
G AUTO COVER SHEET
G SLOW SCAN MODE

AUTO REDUCTION SENDING SETTING

This program is used to have transmitted documents
automatically reduced to match the size of the other
machine's printing paper. When this program is
disabled, documents are sent in their original size, and
because the size is not adjusted to match the size of
the printing paper, part of the received document may
be cut off.
This program is initially enabled (factory default
setting).
PRINTING PAGE NUMBER AT
RECEIVER
Enable this setting to have page numbers appear at
the top of fax pages that you transmit.
This program is initially enabled (factory default
setting).
DATE/OWN NUMBER PRINT POSITION
SETTING
This setting lets you select the position (inside or
outside the original image) of the sender's name and
number that are printed at the top of each fax page you
send. Select [OUTSIDE THE ORIGINAL IMAGE] or
[INSIDE THE ORIGINAL IMAGE].
For more information these settings, see page 44.
The factory default setting is "OUTSIDE THE
ORIGINAL IMAGE".
8
99