Dascom DC-7600 User Manual page 78

Dascom DC-7600
 Error card exit:
 Magnetic/IC Pos:
 Eject Face:
 Card Feed Mode:
 Card thickness:
Card Type
Valid Settings
PVC (Default)
PET
PET-G
Card1（aa，bb）
Card2（aa，bb）
Card3（aa，bb）
35mm/s and 202℃ are the default settings for Card 1-3 (Card Type is cut off
above)
Excessive heat can bend cards. Even optimized retransfer conditions
(speed/temperature) sometimes causes cards to bend. Change this setting
to minimize the degree of bend. User can set up 0-5 (S) for correcting. The
correcting time of front: the default value is "1";The correcting time of
reverse side :the default value is "0"; 1 means correct the bend card for 1
second;0 means do not correct the bend card.
LEFT SIDE\RIGHT SIDE
Front\Back
Auto\Front Up\Back Up
card cassette\Right(Manual)\Right(Auto)
thick\thin
Details
Apply optimized retransfer conditions for standard PVC cards.
Apply optimized retransfer conditions for standard PET cards.
Apply optimized retransfer conditions for standard PET-G cards.
aa= re-retransfer speed, when the value of aa is increased, the re-
retransfer speed get faster; when the value of aa is reduce, the re-
retransfer speed get slower.
bb= default re-retransfer temperature, when the value of bb is increase,
the re-retransfer temperature is increase; when the value of bb is
reduce, the re-retransfer get lower.
65
User Guide V1.0