Control - Siemens SIRIUS 3RW55 Manual

Functions
7.18 3RW5 HMI High Feature
7.18.6

Control

Operating principle
Different control commands can be assigned to the Start button and the favorites keys
F1 - F9.
Requirements
● Access protection to the 3RW5 HMI High Feature is not active or has been reset.
● You are in the "Control" menu.
Control commands
Depending on the application and parameterization, the following control commands can be
issued via the 3RW5 HMI High Feature:
Control command
Select parameter set
Local/Remote
Control motor
Reset
Disable Quick-stop
162
Parameter set 1
(factory setting)
Parameter set 2
Parameter set 3
Motor CW
Motor CCW
Stop motor
Creep speed
Alternative stopping
mode
Pump cleaning start
Description
Select one of the three parameter sets.
One parameter set is deactivated when another
is activated. One parameter set must be active at
all times.
Changes master control
Motor rotates clockwise
Motor rotates counter-clockwise
When creep speed is activated, the control
command appears automatically under the start
key.
The control command can also be executed in
reversing mode (with ext. contactor).
The activation command to the motor is canceled
Activated
•
Deactivated (factory setting)
•
Activate alternative stopping in order to set up an
additional stop in parameter set 1. For more
information, see Chapter Alternative stopping
(Page 107).
This parameter is only visible if the pump
cleaning function has been parameterized. For
more information, see Chapter Pump cleaning
function (Page 126).
Execute a RESET.
Motor does not stop despite pending ON
command from Quick-stop.
Manual, 08/2018, A5E35630887002A/RS-AB/002
SIRIUS 3RW55 soft starter