Emerson Rosemount 8800D Series Quick Start Manual page 11

October 2018
2.2 Install remote electronics
About this task
If you order one of the remote electronics options (options R10, R20, R30, or
RXX), the flowmeter assembly ships in two parts:
1. The meter body with an adapter installed in the support tube and an
interconnecting coaxial cable attached to it.
2. The electronics housing installed on a mounting bracket.
If you ordered the armored remote electronics options, follow the same
instructions as for the standard remote cable connection with the exception
that the cable may not need to be run through conduit. Armored includes the
glands.
Prerequisites
1. Mount the meter body in the process flow line as described in
the
2. Mount the bracket and electronics housing in the desired location. The
housing can be repositioned on the bracket to facilitate field wiring
and conduit routing.
About this task
Refer to Figure 2-9
cable to the electronics housing.
Quick Start Guide
flowmeter.
and these steps to connect the loose end of the coaxial
Quick Start Guide
Mount
11