Sennheiser WiCOS Instruction Manual page 78

Integrating WiCOS into a wired conference system
Initialise Units
2 Automatic Init
Automatic Init
Please wait
Automatic Init
Press ENTER to
Save Initialisation
Initialise Units
1 Manual Init
SDC
76
From the central unit's operating menu, choose with the jog wheel
Conference
" ", "
the other.
Please wait
The text "
When the text "
the display, press the ENTER key †.
The configuration is saved. All connected wired conference units and
the switched-on wireless conference units that were initialized with
the access point are initialized automatically. Any previous
configuration is deleted.
Manually initializing all conference consoles with the central unit
If it is important that the conference units are assigned microphone
numbers in a certain order or if you only want to use certain wireless
conference units, we recommend choosing the manual initialization.
Switch on all wireless conference units that you want to use in your
conference system (see page 31)
Initialize the wireless conference units with the access point integrated
into your SDC 8200 conference and interpretation system (see
page 63).
From the central unit's operating menu, choose with the jog wheel
Conference
" ", "
other.
The red signal light rings
conference consoles flash. With all wireless conference units, the
microphone LED
flashes red.
¶
£
Only the signal light rings of the conference units are flashing while
the signal light rings of the interpreter units remain dark.
Initialization of the interpreter units is via the "
menu (see the instruction manual of the SDC 8200 conference and
interpretation system).
Initialise Units
" and "
" is shown on the display.
Press ENTER to Save Initialisation
Initialise Units
" and "
¶
and „Microphone active" LED
0
flashes red and green and the signal light ring
C CV D DV
V
•
§
:
ç
Automatic Init
" one after
" is shown on
å
Manual Init
" one after the
•
on all wired
2
2
:
Interpretation
"