Sennheiser WiCOS Instruction Manual page 66

Configuring the conference system
C CV D DV
V
:
:
C CV D DV
: A
64
To manually initialize
Switch on all conference units that you want to use in your conference
system (see page 31).
In the "Init Control" box, select the "Manual" option button.
Click "Clear Init
The existing "Units in Init
Click "Start init".
The initialization process starts. All conference units that are
operational show a microphone LED
signal light ring
2
Press the microphone key
initialize.
The microphone LED
conference unit is initialized and listed in the
conference units are assigned microphone numbers in the order of
initialization. These microphone numbers allow you to clearly identify
the conference units.
2
Repeat these steps for all conference units that you want to initialize.
Make sure that no conference units are initialized unintentionally.
:
Use the
conference units are initialized (see page 62).
Click "Save and Stop
The initialization process is stopped. The initialized conference units
are saved in the
signal light ring
When the conference system is switched on the next time, only the
conference units listed in the
conferencing.
In order to increase the safety of your conference system, you can
individually adjust the encryption of the radio communication (see
"Eavesdropping protection and encryption – "Encryption"" on
page 67).
certain conference units with the access point:
List".
List" list will be deleted (where applies).
0
flashing green and red and a
2
flashing red.
A
of the conference unit that you want to
0
and the signal light ring
"Unit Monitoring" function to check that only "wanted"
Init".
"Units in Init List". The microphone LED
2
go off.
"Units in Init
2
go off. The
"Units in Init List". The
0
and the
List" will be used for