Sennheiser WiCOS Instruction Manual page 52

Configuring the conference system
50
There are two ways to integrate the access point into the network and to
use the web server. You can
• integrate the access point into a network with static IP addresses or
• integrate the access point into a network with DHCP.
To call up the IP address settings:
In the main navigation, click "Setup" >
The "TCP/IP Settings" overview screen appears.
To set an unique network identification
In the "System Name" field, type a name for your conference system.
To use a dynamic IP address
From the "IP Address Mode" drop-down list, select "DHCP".
The access point automatically obtains its IP address from a server. In
order to be able to use this function, you need a DHCP server in your
network that automatically assigns IP addresses.
To use a static IP address – "Static":
From the "IP Address Mode" drop-down list, select "Static".
In the "IP Address" field, type the desired IP address.
In the "Subnet Mask" field, type the desired subnet mask.
Make sure that this IP address is not used in your network.
Note down the IP address so that you can call up the web server
again.
Click "Save settings".
The settings are saved.
Switch the access point off and on again (see page 29).
You can now access the web server via the new IP address.
In the address box of the browser, type the new IP address of the access
point.
"TCP/IP Settings".
of the access point:
– "DHCP":