Advantech-DLoG DLT-V6210 Quick Start And Installation Manual page 6

6 Important notes before installation
General:
The DLT-V6210 installation environment must not result in a closed system. The
cooling system of the device requires a supply of fresh air. Otherwise, there is a
danger of overheating and damage to the device.
Overview: Recommended installation steps
1. Find a suitable installation position for the DLT-V6210.
2. Please ensure an ergonomic operability of the DLT-V6210.
Additionally, on vehicles, the driver's field of vision must remain free.
3. Secure the device mounting (mounting bracket, RAM mount) to the
targeted subject/vehicle.
4. Connect external accessories to the DLT-V6210.
5. Install an easily accessible disconnecting device such as a switch close
to the device.
6. Connect all cables (power supply, etc.).
7. Seal cable passages with cable grommets and dummy grommets.
8. Close the DLT-V6210 with the cable cover.
9. Install the DLT-V6210 on the device mounting (follow the mounting
instructions).
In case of installing the DLT-V6210 on vehicles: Observe the vehicle
manufacturer's instructions
− Observe the vehicle manufacturer's instructions about the installation of
peripheral devices. This is particularly important when welding or drilling load
bearing parts.
− Observe the instructions for connecting additional loads, for instance, in
conjunction with an emergency shut-off switch.
− The vehicles must be properly prepared (e.g. connection to the ignition,
correct voltage, etc.)
6