Sensor Select - Smartgen APC615 User Manual

9

SENSOR SELECT

─
When reselect sensors, the sensor curve will be transferred into the standard value. For example,
if temperature sensor is SGD (120°C resistor type), its sensor curve is SGD (120°C resistor type);
if select the SGX (120°C resistor type), the temperature sensor curve is SGX curve.
─
When there is difference between standard sensor curves and using sensor, user can adjust it in
"curve type".
─
When input the sensor curve, X value (resistor) must be input from small to large, otherwise,
mistake occurs.
─
If select sensor type as "None", sensor curve is not working.
─
If there is alarm switch only for the select sensor, user must set the sensor as "None", otherwise,
maybe shutdown or warning occurs.
─
The headmost or backmost values in the vertical coordinates can be set as same as below,
Items
1Pa 1
2
1kgf/cm 9.8x10
1bar 1x10
1psi 6.89x10
APC615 Pump Unit Controller
Fig. 4 – Curve Setting
Table 16 - Common unit conversion table
2
N/m (pa)
1.02x10
4
1
5
1.02
3
7.03x10
Version 1.0
APC615 Pump Unit Controller User Manual
2
kgf/cm
－ －
5
1x10
0.98
1
－
2
6.89x10
2017-10-20
bar (p/in
－
5
1.45x10
14.2
14.5
－
2
1
Page 41 of 54
2
.psi)
4