General Information About Initial Start-Up / Commissioning - Krautzberger MC1 Operating Instructions Manual

Automatic spray gun MC1
CAUTION!
Risk of injury through compressed air!
Uncontrolled leaks of compressed air can lead to serious injuries!
– Prior to any work on the device, all compressed-air lines must be closed and bleed if nec-
essary.
WARNING!
Risk of injury due to hot surfaces!
The surfaces of components can become very hot during operation. Direct contact with hot
surfaces causes severe skin burns.
– Do no touch hot surfaces during operation, wear protective gloves if necessary.
– Ensure that all surfaces have sufficiently cooled down prior to starting any work.
WARNING!
Sound pressure level
Depending on the operating conditions, the sound pressure of the device may cause hearing
damage.
Take suitable action to reduce the impact of the existing sound pressure level. The owner is
responsible for the type and implementation of suitable measures, which may depend on the
local conditions.
7.2

General information about initial start-up / commissioning

Adhere to the following general information for initial start-up / commissioning:
n Only carry out the commissioning of the automatic spray gun pursuant to the steps described
in this operating manual.
n Check the material and compressed air hose lines for damage and tight fit before each use.
n Always observe the applicable country-specific safety, accident prevention, occupational
safety, and environmental protection regulations etc. for the area of use for the automatic
spray gun.
n Do not use sharply abrasive, chemically aggressive, very hot or very cold spray media without
first consulting and receiving approval from Krautzberger GmbH.
Adhere to the spray media manufacturer's safety data sheets.
n
Only operate the automatic spray gun while adhering to the values specified in (
n
13 'Technical data' on page 32).
Only operate the automatic spray gun after proper fastening on a suitable carrier construction.
n
Do not hold the automatic spray gun in your hand during operation.
n
■ 200-0413
ENGLISH
Ä Chapter
GB–21