Install Rail Assembly - Savaria OMEGA Installation Manual

Curved inclined platform lift
Hide thumbs Also See for OMEGA:
Table of Contents

Advertisement

Step 3

Install rail assembly

Install the rail assembly.
Procedure
1
Refer to the plan drawings provided with the lift
(drawings are specific for each job) and take note of
the dimensions and rail configuration.
2
The following diagrams illustrate some of the typical
mounting configurations for the rail. The brackets
between the upper and lower rails can be mounted on
posts or the wall.
Figure 1
Wall mounted
Wall
Step
Figure 2
Post mounted on steps
Post
Railing
Base plate
Step
Figure 3
Post mounted on side of stairs
Post
Railing
Part No. 000823, 06-m02-2012
Spacers
Side of step
Figure 4
Post mounted to wall
Post
Wall plates
Step
Wall mounted (Figure 1)
1
Refer to the measurements on the plan drawings and
place the first tube section of rail against the wall at the
location specified on the plan drawings.
Always double-check the mounting location per the plan
drawings BEFORE DRILLING any holes.
2
Temporarily anchor the first tube section of rail to the
wall through the rail brackets using the appropriate
mounting hardware (not provided). Use shims and
spacers as required. Use a level to make sure the rail
brackets between the upper and lower tubes of the
railway are plumb.
3
Connect the second tube section of rail to the first tube
section using the hardware provided.
a. If necessary, lightly grease each section at the joint
before joining.
b. Secure the rail sections together using the splice
bolts and nuts provided (see below).
c. Check each splice to ensure a clean tight fit and no
damage.
Figure 5
Splice rail sections together
4
Temporarily anchor the second tube section of rail to
the wall through the rail brackets using the appropriate
mounting hardware (not provided). Use shims and
spacers as required. Use a level to make sure the rail
brackets between the upper and lower tubes of the
railway are plumb.
5
Repeat the steps above for each tube section until the
railway is complete. Use the appropriate mounting
hardware (not provided). Use shims and spacers as
required.
Page 5
NOTE
OMEGA IPL Installation Guide

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents