Savaria OMEGA Installation Manual page 26

Page 26
7 Adjust the platform slider as required.
a. Reassemble the swivel link between the platform
and the carriage.
b. The platform slider must touch the bearing support
on both sides (see below). This can be adjusted by
changing the length of the swivel link between the
platform and the carriage.
Each time you adjust the horizontal alignment of the
platform, you must adjust the slider again as well.
Figure 67
Slider adjustment
c. Adjust the limit switch S11p (on both sides) until the
switch makes contact with the platform slider.
Figure 68
Limit switch S11p
OMEGA IPL Installation Guide
NOTE
Platform
slider
Slider must
touch bearing
support on
both sides
Swivel link
Bearing
for lifting
platform
8 Check the horizontal position of the arms. They are pre-
adjusted at the factory but may need adjustment on
site.
9 Adjust each arm separately. Loosen the screws (see
below), adjust the arm as required and then tighten the
screws.
Figure 69
Adjust screws for arms
S11m
10 Adjust limit switch S11m (on both sides) so the arms are
in the horizontal position when the automatic platform
is opened.
11 Adjust limit switch S11o (on both sides) so the platform
is pressed towards the carriage by the automatic drive
when the platform is closed.
Figure 70
Limit switch S11o
S11m
Part No. 000823, 06-m02-2012