Related Manuals for Savaria V1504
Summary of Contents for Savaria V1504
- Page 1 V1504 Vertical Platform Lift OWNER’S MANUAL (To Be Retained by Owner After Installation by Authorized Savaria Dealer) Part No. 000692 30-m06-2017...
- Page 2 IMPORTANT Ensure that only an authorized Savaria Dealer installs and services the V1504 Vertical Platform Lift. Under no circumstances is anyone other than a dealer with Savaria training and authorization to install, adjust, service or modify any mechanical or electrical device on this equipment. Failure to follow this warning can result in safety system compromises or defeat;...
-
Page 3: Table Of Contents
Operator Troubleshooting ........18 Part No. 000692, 30-m06-2017 V1504 Owner’s Manual... -
Page 4: To Ensure Safe Operation
Ensure that only qualified personnel perform maintenance and service on the unit. • When replacing parts, be sure that only genuine Savaria parts are used. • This unit is intended for use by a mature person who understands its proper operation as set out in this manual. -
Page 5: Description
1. DESCRIPTION Figure 1 shows the exterior components of a V1504 (with a Type 1 cab and without an enclosure). Figure 1 Tower cap Tower Tower service panels Car operating panel (COP) Handrail Manual Type 1 cab lowering device Pit swtich... -
Page 6: General Specifications
Modular 8 ft (2.4 m) base guide rail assembly Tower Roller guide support Pit depth requirement 3” (76.2 mm) Beige electrostatic powder coat paint on all steel Finish surfaces and vacuumed formed plastics V1504 Owner’s Manual Part No. 000692, 30-m06-2017... - Page 7 V1504 Specifications (continued) 115 VAC operation (115 VAC up direction; 12 VDC battery down direction) Call/send stations at landings Continuous-pressure type buttons Operating control buttons on platform Automatic battery recharging system (115 VAC) Remote manual lowering device Standard features Low-voltage controls...
-
Page 8: Operation
2 Press the appropriate landing button to move the lift to the destination. Note that the V1504 will not move if one of the doors is open. 3 When the lift reaches the landing, the door will unlock automatically (for units with mechanical GAL locks). -
Page 9: Operating From The Landing Station Controls
2 Press the appropriate button to move the lift in the required direction. Note that the V1504 will not move if one of the doors is open. 3 When the lift reaches the landing, the door will unlock automatically (for units with mechanical GAL locks). -
Page 10: Additional Features
The safety underpan (shown in Figure 5) is located under the platform. The underpan has sensors that detect any obstacles and stop the downward travel of the lift. This is optional on enclosed units and required on open hoistways. Figure 5 V1504 Owner’s Manual Part No. 000692, 30-m06-2017... -
Page 11: Door Locks
Pull the door open and then turn the key a half turn counter-clockwise to remove it from the lock. DO NOT open the door if there is any chance of falling into the hoistway or from the platform. Figure 6 Part No. 000692, 30-m06-2017 V1504 Owner’s Manual... - Page 12 Figure 7 For units with a GAL lock, the door can be opened manually using a special key inserted into the round pin on the front of the lock (Figure 8). Figure 8 V1504 Owner’s Manual Part No. 000692, 30-m06-2017...
-
Page 13: Safety Brake
Pressing one of the red Emergency Stop buttons during travel will stop the lift immediately and activate the alarm. The Emergency Stop overrides the landing (call/send) stations. Pull the Emergency Stop out to return the lift to normal operation. Part No. 000692, 30-m06-2017 V1504 Owner’s Manual... -
Page 14: Manual Lowering And Battery Lowering System
For units with a 120 VAC pump, the manual lowering box (Figure 10) is located on the side of the V1504. When you pull on the steel cable located inside the manual lowering box, the platform descends to ground level. -
Page 15: Maintenance
DANGER Always use the shoring pins when working under the lift. For lower travel heights, insert the pins into the lower holes (at 600 mm). Figure 11 Shoring pin hole Shoring pin Part No. 000692, 30-m06-2017 V1504 Owner’s Manual... -
Page 16: Maintenance Schedule
Check for oil leaks. Every 6 months Check the rollers. Every 6 months Ensure that all filler panels (aluminum, Plexiglas or glass) are Every 6 months securely fastened in the enclosure, doors and gates. V1504 Owner’s Manual Part No. 000692, 30-m06-2017... -
Page 17: Maintenance Record
Maintenance Record Date Time Reason for Call Comments Dealer Part No. 000692, 30-m06-2017 V1504 Owner’s Manual... -
Page 18: Operator Troubleshooting
Check to see if the Emergency Stop is pushed in; Platform does not move it should be pulled out for normal operation. If the platform is at the top landing, check the underpan sensor as described above. V1504 Owner’s Manual Part No. 000692, 30-m06-2017... - Page 20 Authorized Savaria Dealer V1504 Vertical Platform Lift OWNER’S MANUAL Part No. 000692 Copyright 2017 Savaria Concord Lifts, Inc. 2 Walker Drive Brampton, Ontario, L6T 5E1, Canada www.savaria.com For service or questions about this product, please contact your installing dealer. DEALER NAME:...