Table of Contents
Advertisement
WARNING!
Risk of fatal injury, risk of injury or property damage due to damaged or disconnected
lines!
Damaged or disconnected lines can cause death, serious injuries or property damage due to
whip-like movements and the spraying of fluids.
Note:
–
Check the fluid pressure lines for damage and a tight fit prior to every work process.
7.2
General information about start-up / commissioning
Adhere to the following general information for commissioning:
n
Only carry out the installation and commissioning of the hand-held spray gun in accordance
with the steps described in this operating manual.
n
Check the material and compressed air hose lines for damage and tight fit before each use.
n
Always observe the applicable country-specific safety, accident prevention, occupational
safety, and environmental protection regulations applicable for the area of use for the hand-
held spray gun.
n
Do not use sharply abrasive, chemically aggressive, very hot or very cold spray media without
first consulting with and receiving approval from Krautzberger GmbH.
Adhere to the safety data sheets of the spray media manufacturer.
n
Only operate the hand-held spray gun in compliance with the values specified in (
n
13 'Technical data' on page 55).
n
Never point the compressed air or the spray jet at living beings.
n
Only use sufficiently sturdy hoses! Check and, if necessary, replace older hoses before
starting up the hand-held spray gun.
n
Only use hoses that match the hose connections and check them for their proper seat and
ensure that they are leak-proof.
n
It is recommended to flush the hand-held spray gun prior to commissioning using a suitable
cleaning product (spraying process with cleaning product, until it runs clear when exiting).
n
To ensure that there are no particles clogging the nozzles, we recommend to clean the
coating material with a material filter positioned in front of the fluid connection (high pressure
material filters can be purchased from Krautzberger GmbH).
n
To achieve a unified coating thickness and spray pattern for high-quality coatings, a cross-
coating process is recommended, which means that the area is first coated in horizontal lines
and then in vertical lines.
Among other factors, the spray pattern depends on the viscosity of the coating material. It can
be modified through the fluid pressure. If the optimal application cannot be achieved through
fluid pressure changes, it is recommended to try again with a different fluid nozzle.
GB–20
Operating instructions
T-Dok-198-GB-Rev.3
mail@krautzberger.com, www.krautzberger.com
Ä Chapter
Advertisement
Table of Contents
