Table of Contents
Advertisement
Hand-held Spray Gun KS 5K
WARNING!
Risk of fatal injury, risk of injury or property damage due to damaged or disconnected
lines!
Damaged or disconnected lines can cause death, serious injuries or property damage due to
whip-like movements and the spraying of fluids.
Note:
–
Check the fluid pressure lines for damage and a tight fit prior to every work process.
6.2
General information about start-up/commissioning
Adhere to the following general start-up/commissioning information:
n
Only carry out the start-up and commissioning of the hand-held spray gun in accordance with
the steps described in these operating instructions.
n
Always observe the applicable country-specific safety, accident prevention, occupational
safety, and environmental protection regulations for the area of use for the hand-held spray
gun.
n
Adhere to the spray media manufacturer's safety data sheets.
n
Only operate the hand-held spray gun in compliance with the values specified in (
12 'Technical data' on page 43).
Only use accessories from Krautzberger GmbH!
n
Only use sufficiently sturdy hoses! Check and, if necessary, replace older hoses before
n
starting up the hand-held spray gun.
n
Only use hoses that match the hose connections and check them for their proper seat and
ensure that they are leak-proof.
n
It is recommended to flush the hand-held spray gun prior to start-up using a suitable cleaning
product (spraying process with cleaning product, until it runs clear when exiting).
n
To ensure that there are no particles clogging the nozzles, we recommend to clean the
coating material with a material filter positioned in front of the fluid connection (high pressure
material filters can be purchased from Krautzberger GmbH).
In contrast to compressed air-operated hand-held spray guns, the spray pattern of airless
devices can by default not be changed through settings on the nozzle. If a different spray pat-
tern is desired, the airless-nozzle must be exchanged.
Among other factors, the spray pattern depends on the viscosity of the coating material. It can
be modified through the fluid pressure. If the optimal application cannot be achieved through
material pressure changes, it is recommended to try again with a different nozzle screw.
■ 200-0379
ENGLISH
Ä Chapter
GB–19
Advertisement
Table of Contents
