Table of Contents
Advertisement
4.
OPERATIONS OF REMOTE CONTROL UNITS
IN PROMIG 200 AND 300 WIRE FEED UNITS
R20
R63
................ R63 ....................................................... R61
MIG ......... Setting for wire feed: ............................. Setting for voltage:
................ I 1...18 m/min
................ II 1...25 m/min ....................................... 10 V...max. voltage of power source (35...46 V)
MMA ....... Setting for power:
................ 10 A...max. power of power source ....... NO OPERATION
R10
................ R61
MIG ......... Setting for wire feed:
................ I 1...18 m/min
................ II 1...25 m/min
MMA ....... Setting for power:
................ 10 A...max. power of power source
5.
SERVICE, OPERATION DISTURBANCES
The amount of use and the working environment should be taken into consideration when
planning the frequency of maintenance of Promig. Careful use and preventive maintenance will
help to ensure trouble-free operation.
The following maintenance operations should be carried out at least every six months:
Check:
- The wear of the grooves of the feed rolls. Excessive wear of grooves
causes problems in wire feed.
- The wear of the wire guide tubes of wire feed. Badly worn feed rolls
and wire guide tubes should be discarded.
- The wire guide tube in the gun should be set as near the feed rolls as
possible, but not touching them and the wire must follow a straight line
from the end of the feed roll.
- Reel brake adjustment
- Electric connections
* Oxidized couplings must be cleaned
* Loose couplings must be tightened
Clean dust and dirt from the equipment.
When using compressed air, always protect your eyes with proper
eye protection.
In case of problems contact the KEMPPI works in Lahti, Finland or your KEMPPI dealer.
18 – PROMIG 200, PROMIG 300 / 0537
R61
R61
twice a
year
© KEMPPI OY
Advertisement
Table of Contents
