Operations Of Remote Control Units In Kwf Wire Feed Unit - Kemppi WELDFORCE KWF 200S Operation Instructions Manual

4. OPERATIONS OF REMOTE CONTROL UNITS IN
KWF WIRE FEED UNIT
R63
R20
R63
MIG Setting for wire feed:
I 1...18 m/min (39.3...709 ipm)
II 1...25m/min (39.3....984 ipm)
Memory Channel selection: 1...5 corresponding
to settings 1, 4, 6, 8, 10 of knob
SYNERGIC MIG Setting for power (wire feed speed):
according to wire min. ... max.
MMA Setting for power:
10 A ... max. power of power source
R10, RMT10
R61
MIG Setting for wire feed:
I 1...18 m/min (39.3...709 ipm)
II 1...25m/min (39.3....984 ipm)
Memory
Channel selection: 1...5 corresponds
in the R10 settings
1, 4, 6, 8, 10 of knob
SYNERGIC MIG Setting for power (wire feed speed):
according to wire min. ... max.
MMA Setting for power:
10 A...max.power of power source
© KEMPPI OY
R61
R61
Setting for voltage:
10 V...max. voltage of power
source (35...46 V)
Fine adjustment for arc
length:1...10
Fine adjustment for arc length:
1...10
NO OPERATION
R61
RMT 10 remote control unit for
PMT/WS gun
Setting for wire feed:
I 1...18 m/min (39.3...709 ipm)
II 1...25m/min (39.3....984 ipm)
Channel selection 1 ...5
Setting for power (wire feed speed)
according to wire min. ... max.
(see page 18, part 10)
NOTE!
RMT10 NO OPERATION
WeldForce KWF 200S / 0541 – 17