Table of Contents
Advertisement
TROUBLE-SHOOTING
AND
MAINTENANCE
Inspectand tighlenall parts each time you usethe CROSS TRAINERe. Replace any warn parts immediately. Outside
surfacesof the CROSS TRAINERe can be cleaned using a damp clothand mild detergent. Keep all liquids away from
the stepperconsole and the PERSONALTRAINER computer. Most CROSS TRAINER• problems can be solvedby follow-
ing the slaps below. Find the applicable symptom and fallow the slap(s)lided. If further assistanceis needed, call our
Customer ServiceDepadment toll-free at 1-800-999-3756,
Monday throughFriday, 6 a.m. until'6 p.m. Mountain
.time (excluding holidays).
1. SYMPTOM: THE PERSONALTRAINER COMPUTER DISPLAYS AN ERROR CODE ("EEE")
a. While theweightsettingischanging, the motor
willbeheard andtheSETS a nd
REPS
displays w illshow
a rapidly
rotatingindicator. To preventdamage to the weight system,do not put any pressureon the leg developer,arms
or cableswhile the weight settingischanging. Ifthe tat bar or rower bar is attached to the high pulley station,restit
in the rock near the high pulleystation.Wait for.the soundof the motorto stop before you continue. If the comput-
er senses pressure on the weight systemwhile the weight settingischanging, the WEIGHT display will show an
• error code ("EEE")for two seconds,and the weight settingwill sl-op changing. The WEIGHT dis'pla), w ill then show
the current weight setting.Make sure that there is no pressureon the leg developer, arms or cables. Pressthe
increaseor decrease button beneath the WEIGHT display to changethe weight settingas desired.
2. SYMPTOM: THE MAIN CABLE DOES NOT MOVE SMOOTHLY, OR THERE IS SLACK IN THE MAIN CABLE
a. Inspect t he routingof thecables and make sure that they are in the grooves in all of the pulleys.If they are not,
tarred the problem. If the cables are not properly routed, they will be damaged when used..
b. If there is slackin the Main Cable (51), locate the
AdjustmentBracket(53) near the bottom of the
....
right side shield.Hold the end of the Weight Cable
(52) firmly, and slidethe Adjustment Bracket far-
ther ontothe Weight Cable. Tighten the 5/16" Nut
(82) ogaiest the AdjustmentBracket. Testthe Main
Cable. If the mator stallsor hesitates,loosen the
5/16" Nut slightly.If the 5/16" Nut is tightened as
far as passible and there is still slack, the Main
Cable shouldbe replaced. See ORDERING
REPLACEMENT PARTSon the back cover of this
ownerls
monuok
3.- SYMPTOM:THE STEPPER CONSOLE DOES NOT
FUNCTION PROPERLY
a, As you step, movethe stepper pedals vertically at
least 8 inches.If)our stepsare too shallow, the
movementof the stepperpedals will not be detect-
ed. If the stepperconsolestilldoes not function
properly, the Reed Switch(99) con be adjusted by
sliding the barrel of the ReedSwitch up and down
slightly. Repeatuntil the stepperconsole displays
correctfeedback. If necessary,the 3/4" Screw
(119} attaching the Reed Switch Bracket(120) can
be loosenedand the positionof the Bracket can be
adjusted.
51
120
I
119/
IE
99
/
\
\
_ounting
eeye
25
Hide quick links:
Advertisement
Table of Contents
