ProForm 831.159341 Owner's Manual page 6

.
Insert the lower enc[of the LeftArm (15) into the left
side of the Moment Ann (74). Make sure that the
bracket on the end of the LeftArm is positionedas
shown in the insetdrawing. If the bracket is nat
positioned as shown, the LeftAnn will not function
properly.
Top a 3/4" PlasticCap (57) onto one of the ends of
a 3/4" x 4" Axle (54). Align the hole in the end of
the LeftArm (15} with the holes in the Moment
(74). Insert the Axle into the Moment Arm and the
LeftArm. Tap a 3/4' PlasticCap onto the Axle.
Nole: An extra 3/4" Plastic Cap (57) has been
included with the hardware pock. If you accldenlal-
ly damage one of He Caps during assembly, use
this extra Cap. Otherwise, the extra Cap may be
discarded.
Attach the Right Arm (16) in the same manner.
8. Wrap the Weight Cable (52) under a 3 1/2" Pub/
15).Attach the Pulleyand a Cable Trap (67) to the
back of the Upright (9) with a 3/8" x 1 3/4" Bolt
(40) and 3/8" Nylock Nut (6). Make sure that the
Cable Trap is in the "7 o°dock" position.
Laythe Weight Cable (52) over a 3 1/2' Pulley(51.
_toch o Cable Trap (67) and the Pulley to the I_
side of the Upright (9) with a 3/8" x 1 3/4" Bolt
(40) and 3/8" Nylock Nut (6). Make sure that the
Cable Trap is in the "12 o'cbck" position.
Wrap the Weight Cable (52) around a 2" Pulley(4).
h'_ch the Pulleyto the LeftAnn (15} with a 3/8" x
1 3/4" Bolt (40} and 3/8" Nylock Nut (6).
9. Wrap the Weight Cable (52} around a 2 3/4"
Pulley1131.,_ach the Pulleyto the indicated bracket
on the Upright 19) with a 3/8" x 1 3/4" Bolt(40)
and 3/8" Ny!ock Nut (6).
8
9
15
,/"
/ [
/
C_rrect position of Arms
against Moment Arm
74
INCORRECI" CORRECT
5