The Power Does Not Turn On; There Is A Clicking Sound When Using The Arms - ProForm 831.159341 Owner's Manual

b.
If the LCD display becomes dim, the 1.5-volt watch
batteries in the Stepper Console (88) should be
replaced. Using a shortphillips screwdriver,
remove the two screws attaching the back of the
Stepper Console. Using the screwdriver,carefully
push the two ba_ries out of the barry d;ps; be
careful to note which way the batteries ore turned.
Insert two new 1.5-yah watch batteries into the
battery clips. Reat/achthe back of the Stepper
Console.
1.5-Volt
Watch
Batteries
4. SYMPTOM: THE POWER DOES NOTTURN ON
a. Make sure that the transformeris fullyplugged into the jack on the CROSS TRAINERe, and into a 12a-volt outlet.
5. SYMPTOM: THERE IS A CLICKING SOUND WHEN USING THE ARMS
a,
Tigh_ theindica_d 3/8" Nylock N ut(61 further
onto the 3/8" x 3 1/2" Bah (42) on each Arm
(15, 16) until the Swivel Brackels(141 do not slide
back and forth on the Balls. Becareful not to over-
tighten the Nylack Nuls; the SwivelBrackets must
be able to swivel easily.
© 1994 Sears, Roebuckand Co.
26