ProForm 831.159341 Owner's Manual page 8

14. Attach the Seal (28} to the Upright (9) with the two
1/4" x 5/8" Baits (20} and a 1/4" x 2"
Bolt ( 118).
15. Center one Pod Tube (22) in the Upright (9), and the
other Pod Tube in the Leg Developer (23). Slide the
four Small Pads (17) onto the ends of the Pad Tubes.
16. Restth.eLeftand Right Pedals (75, 76] on the honks
• at the lower ends of the Resistance Cylinders (84).
Make sum that the hooks are f_ily inserted into the
same slots under both Pedals.
Hug theTransformer (39) intothe jackIocalednear
thebottomof theRightSideShield (12).
14
16
//17
9
84 39,
76
17. Make surethat all padsare properlytightened. Theuseof all remaining padswill be exploined in ADJUSTING
THE•CROSS T RAINER e, beginning on page8 of thisowner'smanual.
18. Before using the CROSS TRAINER e, test the cables and the pulleys.Make sure that the cables are ;n the grooves
in the pulleys. If the cables do not move smoothlyover the pulleys, locate and corred the problem before using
i the CROSS 1RAINER e. If the cables are not properly routed, they will be damaged when used.
7