Maintenance And Trouble-Shooting - ProForm PFMC77754 User Manual

OPERATING THE ELECTRONIC MONITOR
1. To turn on the power, press the on/clear button or
simply begin exercising on the AIR WALKER. The
entire display will appear for two seconds. The
electronic monitor will then be ready for operation.
2. Select one of the five modes:
Scan all modeÑWhen the power is turned on, the
scan all mode will be selected automatically. The
scan all mode can also be selected by repeatedly
pressing the mode button. One mode indicator will
show that the scan all mode has been selected,
and a second mode indicator will show which
mode is currently displayed.

MAINTENANCE AND TROUBLE-SHOOTING

MAINTENANCE
Inspect and tighten all parts of the AIR WALKER reg-
ularly. Replace any worn parts immediately.
The AIR WALKER can be cleaned with a soft, damp
cloth. Keep liquids away from the electronic monitor.
Keep the monitor out of direct sunlight or the display
may be damaged. Remove the batteries when storing
the AIR WALKER.
ELECTRONIC MONITOR TROUBLE-SHOOTING
If the electronic
monitor will not turn
on, the batteries
should be checked.
Using a coin, pry up
the front of the
monitor and remove
it from the console
(see figure 1).
See figure 2. If there
is a gap between
the positive (+) ends
of the batteries and
the metal contacts,
the monitor will not
turn on. Push the
batteries to make
sure that the posi-
tive ends are
touching the metal
contacts.
Fig. 1 Console
Coin
Monitor
Fig. 2 Metal Contact
Batteries
Metal Contact
Back of Monitor
Reps/min, reps, calories, or time modeÑThese
modes can be individually selected by repeatedly
pressing the mode button. The mode indicators
will show which mode has been selected. (Make
sure that the scan all mode is not selected.) The
modes will be selected in the following order:
reps/min, reps, calories, scan all, time.
3. The monitor has an auto-off feature to turn off
the power. If the pedals are not moved and the
monitor buttons are not pressed for four minutes,
the power will turn off automatically in order to
conserve the batteries.
To reset the LCD display, press the on/clear button.
See figure 3. Make
sure that the reed
switch wire is plugged
into the monitor; insert
any excess wire into
the console. Snap the
monitor into the con-
sole. Make sure that
the wire is not pinched
between the monitor
and the console.
If the electronic monitor still does not function proper-
ly, the batteries should be replaced. Two ÒAAÓ batter-
ies are required; alkaline batteries are recommended.
Remove the two old batteries from the monitor, and
insert two new batteries. Make sure that the nega-
tive (Ð) ends of the batteries are touching the
springs, and that the positive (+) ends of the bat-
teries are pushed against the metal contacts.
8
Fig. 3
Monitor
Console
Reed Switch Wire