Trouble-Shooting And Maintenance - ProForm 831.15934 Owner's Manual

_°
AI"T._,CHING THE I-AT BAR, ROWER BAR OR
STRAP TO THE LOW PULLEY STATION
Attach the Lot Bar {36} to the Main Cab}e (51) with a
Cable Clip (33). For some exercises, the Chain (38}
should be attached betweenthe LOtBar and the
Maln Cable wlth two Cable Clips. Adjust the length
of the Chain between the Lot Bar and the Main
Cable so the Lot Bar is in the correct starting posi-
tion for the exercise to be performed.
The Rawer Bar (34} or the Strop (35) can be
altached in the same manner.
34
38
33
TROUBLE-SHOOTING AND MAINTENANCE
Inspect and tighten all parts each time you use the CROSS TRAINER e. Replace any worn ports immediately. Outside
surfaces of the CROSS TRAINER e can be cleaned using a damp clothand mild detergent. Keep all liquids away Earn
the stepper console and the PERSONAL TRAINERcomputer.
Most CROSSTRAINER e problems can be salved by follow;ng the steps below. F_ndthe applicable symptom and follow
the step(s) listed. If further ossis_nce is needed, coil our Customer Service Department toil-free at 1-800-999-3756,
Monday through Friday, 6. a.m. until 6 p.m. Mountain .time (excludlng holldays).
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the transformer is
fully
plugged into the jack on the CROSS TRAINERe, and into a 120-volt ou_et.
2. SYMPTOM" THE MAIN CABLE DOES NOT MOVE SMOOTHLY, OR THERE IS SLACK IN THE MAIN CABLE
a. Inspect the routing of the cables and make sure that they are in the grooves in all of the pulleys. If they are not,
correct the problem. If the cables are not properly routed, they will be damaged when used.
b,
If there
is slack in the Main Cable (51}, locate the
Adjustment Bracket (53) near the bottom of the
right side shleld. Hold the end of the Weight
Cable (52) Firmly, and s}ide the Adjustment
Bracket farther onto the Weight Cable..tighten
the 5/16" Nut (821 against the Adjustment
Bracket. Test the Main Cable. IFthe motor stalls
or hesitates, loosen the 5/16" Nut slightly, ff the
5/16" Nut is tightened as Faras Passib}e and
there is still slack, the Mo;n Cable should be
replaced. See ORDERING REPLACEMENTPARTS
on the back cover oF th_sowner's manual.
13
\
53 52
51
9