Mounting Installation - Planet IGTP-802T User Manual

1. The wire gauge for the terminal block should be in
the range of 12 ~ 24 AWG.
2. Alarm relay circuit accepts up to 30V, max. 3A
Note
currents.
Fault Alarm Contacts

2.2 Mounting Installation

This section describes how to install the Industrial 802.3at PoE Media
Converter and make connections to it. Please read the following topics
and perform the procedures in the order being presented.
In the installation steps below, this Manual uses IGS-
801(PLANET 8 Port Industrial Gigabit Switch) as the
example. However, the steps for PLANET Industrial
Switch & Industrial Media/Serial Converter are similar.
The term "Industrial Equipment" in the following
Note
section means PLANET Industrial devices mentioned
above.
The Fault Alarm Contacts are
energized (CLOSE) for normal
operation and will OPEN when
failure occurs
Fault
19