5.2 Chassis Installation and Rack Mounting
To install the EoC Converter in a 10-inch or 19-inch Converter
Chassis with standard rack, follow the instructions described
below.
Step 1: Place your VC-232G on a hard flat surface, with the
front panel positioned towards your front side.
Step 2: Carefully slide in the module until it is fully and firmly
fitted into the slot of the converter chassis.
Step 3: Attach a rack-mount bracket to each side of the
Converter Chassis with supplied screws attached to the
package.
Step 4: After the brackets are attached to the Converter
Chassis, use suitable screws to securely attach the
brackets to the rack.
Step 5: Proceed with Step 4 and Step 5 of the 2.1 Installation
section to connect the network cabling and supply
power to your Converter Chassis.
You must use the screws supplied with the
mounting brackets. Damage caused to the parts
by using incorrect screws would invalidate your
warranty.
18