Chassis Installation And Rack Mounting - Planet VF-101-T User Manual

Figure 3-1 VF-10x-T / VF-10x-R stand alone installation

3.3 Chassis Installation and Rack Mounting

To install the Video over fiber Converter in a 10-inch or 19-inch Converter Chassis with standard rack, follow the
instructions described below.
Step 1: Place your Converter Chassis on a hard flat surface, with the front panel positioned towards your front side.
Step 2: Carefully slide in the module until it is fully and firmly fitted into the slot of the Converter Chassis.
Figure 3-2: Insert a video over fiber converter into an available slot
Step 3: Attach a rack-mount bracket to each side of the Converter Chassis with supplied screws attached to the package.
Step 4: After the brackets are attached to the Converter Chassis, use suitable screws to securely attach the brackets to
the rack.
Step 5: Proceed with the steps 4 and steps 5 of session 3.2 Stand-alone Installation to connect the video and fiber
cabling and supply power to your Converter Chassis.
12