Planet IGTP-802T User Manual page 24

IGTP-805AT 100/1000BASE-X Installation:
The IGTP-805AT is flexible enough to extend the distance from 220m
to 120km. It depends on the 100M/1000M mini GBIC modules. The
SFP transceivers are hot-plug and hot-swappable. You can plug in and
out the transceiver to/from any SFP port without having to power down
the Industrial 802.3at PoE Media Converter.
To install IGTP-805AT with 100BASE-FX, 1000BASE-SX/LX SFP, simply
complete the following steps:
Step 1: Slot in the 100BASE-FX, 1000BASE-SX/LX SFP. Make sure
both sides of the SFP transceiver are with the same media
type, for example: 100BASE-FX/2km to 100BASE-FX/2km,
1000BASE-SX/220m
550m, 1000BASE-LX/10km to 1000BASE-LX/10km.
Step 2: Connect the fiber cable. Attach the duplex LC connector on
the network cable to the SFP transceiver.
SFP Module
Fiber Switch
LOCATION A
Figure 2-5: IGTP-805AT 100/1000BASE-X Installation
It is recommended to use PLANET MFB/MGB series
100BASE-FX/1000BASE-SX/LX/LX
IGTP-805AT. If you insert an SFP transceiver that is not
Note
supported, the IGTP-805AT will not recognize it.
24
& 550m to 1000BASE-SX/220m
DC 12V~48V, AC 24V
SFP Module
LOCATION B
WDM
&
RJ45
PoE IP Camera
SFP on the