Chassis Installation And Rack Mounting - Planet ICS-100 User Manual

2.2.2 Chassis Installation and Rack Mounting

To install the Media Converter in a 10-inch or 19-inch with standard rack, follow the instructions described below.
Step 1: Place your ICS-10x on a hard flat surface, with the front panel positioned towards your front side.
Step 2: Carefully slide in the module until it is fully and firmly fitted into the slot of the chassis.
Attach a rack-mount bracket to each side
Step 3:
Step 4: After the brac kets are attached to the chassis, use suitable screws to securely attach the brackets to the rack, as
shown in Figu re 2-9.
Step 5: Precede with the steps 4 and steps 5 of session 2.2.1 Stand-alone Installation to connect the network cabling
and supply power to your converter.
You must use the screws supplied with the mounting brackets. Damage caused to the parts by using
incorrect screws would invalidate your warranty.
Figure 2-8 Insert a Media Converter into an available slot
of the Chassis with supplied screws attached to the package.
Figure 2-9 Mounting the Chassis in a Rack
-13-
User's Manual of ICS-10x