Fiber Installation - Planet IGTP-802T User Manual

2.2.3 Fiber Installation

IGTP-802T/IGTP-802TS 1000BASE-X Installation:
To install an Industrial 802.3at PoE Media Converter stand-alone, on a
Track or wall mount, simply complete the following steps:
Step 1: Turn off the DC power of the device/station in a network to
which IGTP-802T/IGTP-802TS will be attached.
Step 2: Ensure that there is no activity in the network.
Step 3: Attach fiber cable from the Industrial 802.3at PoE Media
Converter to the fiber network. TX, RX must be paired at
both ends.
Step 4: Connect the DC power to the IGTP-802T/IGTP-802TS and
verify that the Power LED lights up.
Step 5: Turn on the power of the device/station; the PWR LED
(Green) should light when all cables are attached.
SFP Module
Fiber Switch
Location A
Figure 2-4: IGTP-802T/IGTP-802TS Stand-alone Installation
Please refers to APPENDIX-A for detailed wiring infor-
mation of the Industrial 802.3at PoE Media Converter.
To prevent from optic acceptor malfunction, check the
both wires / transmitter before power on the Industrial
Note
802.3at PoE Media Converter.
DC 12~48V, AC 24V
PoE IP Camera
RJ45
Location B
23