5.2 – Cover (Top)
The Cover is fastened to the Cabinet by 2 screws located in its rear side.
Release the 2 rear screws;
Raise the rear side of the Cover a little;
Pull it to the front.
5.3 – Timer Protective (Cover)
The Timer Protective is located in the internal rear side of the Cover. This part protects the Electronic
Control (PCB) against water sprays that can occur during the Washer operation.
Remove the Cover;
Release the 2 screws that fasten the Timer Protective;
Pull it out.
5.4 – Pressure Switch
The Pressure Switch determine the Washer water level.
This Washer has:
2 Levels set by Pressure Switch : High Level and Medium Level (according with the program selection).
We identify below, for each Pressure Switch level, a height reference for water in basket. The reference
adopted is the hole row covered by water.
These references are approximate and small variations can occur depending on each case.