Table of Contents
Advertisement
Washer Function test
Note: All of these sequence below, will be operated by the PCB automatically.
d) After a few seconds, the Electronic Control (PCB) will activate the Cold water inlet Valve for 3 seconds,
then it will stop and the Hot water inlet Valve will be activated for more 3 seconds at this time the SUPER
WASH Program led will turn off and the REGULAR WASH PROGRAM will light on.
e) The Washer will agitate for 5 seconds, at this time the REGULAR WASH Program led will turn off and
the FAST WASH Program led will light on;
f) The agitation will stop and the drainage will start, at this time the FAST WASH Program led will turn off
and the SPIN Program led will light on;
Wait until the drainage operation is concluded, then the Washer will start the spinning cycle.
g) Press ON/OFF key to leave the test routine.
Note: If you don't press the ON/OFF key the spinning cycle won't stop.
DISMOUNTING
•
Remove the Cover;
•
Release the Timer Protective;
•
Release the screw that fasten the Electronic Control (PCB), subsequently remove the PCB releasing
the support that fasten it.
MSEX0060i
Supports that
fasten the PCB.
Screw that
fasten the PCB.
30
Advertisement
Table of Contents
