Table of Contents
Advertisement
CALLED
Does not turn on.
No water inlet.
(Hot or Cold)
MSEX0060i
CAUSE
ON/OFF key not activated.
Lid open.
No water.
No power supply.
Low voltage at Mains.
Lid switch open.
Lid micro-switch wiring harness broken.
Wiring Harness bad/broken.
ELECTRONIC CONTROL board with problems.
Tap closed.
No water supply.
Inlet hose clogged.
Water inlet clogged or low pressure.
Lid switch open.
Lid micro-switch wiring harness broken.
Inlet Valve with problem.
ELECTRONIC CONTROL (PCB) with
problems.
SOLUTION
Press ON/OFF key.
Close the lid (washer does not
operate with lid open).
Check whether or not tap is closed
or if there is water.
Turn on cut-out switch or await
power supply return.
Check the installation
Replace Lid Switch.
Measure continuity between
involved wires. (R = 0).
Connect/replace Wiring Harness.
Replace the Electronic board
(PCB).
Open tap.
Wait the water supply return.
Remove the object that is clogging
the Inlet Hose or replace it.
Unscrew tap hose and proceed
with cleaning procedures
recommended in Installation
Guide.
Replace Lid Switch.
Measure continuity between
involved wires. (R = 0).
Replace Inlet Valve.
Replace the Electronic board
(PCB).
33
Advertisement
Table of Contents
