Whirlpool WWCR-9230 User Manual

Washing machine
Hide thumbs

Advertisement

30106390GB.fm Page 1 Tuesday, February 22, 2011 2:56 PM
DEFINITION OF USE
This washing machine is exclusively destined to
wash and spin machine washable laundry in
quantities which are usual for private households.
• Observe the instructions given in these Instructions
for Use, the Installation Guide and the Programme
Chart when using the washing machine.

BEFORE USING THE WASHING MACHINE

1.Removing the packaging and inspection
• After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use the
washing machine. Contact After-Sales Service or
your local retailer.
• Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children,
as they are potentially dangerous.
• If the appliance was exposed to the cold prior to
delivery, keep it at room temperature for a few
hours before operating.
2.Remove the transport bolts
• The washing machine is fitted with transport
bolts to avoid any possible damage to the interior
during transport. Before using the machine, it is
imperative that the transport bolts are removed.
imperative that the transport bolts are removed.
imperative that the transport bolts are removed.
• After their removal, cover the openings with the
After their removal, cover the openings with the
After their removal, cover the openings with the
4 enclosed plastic caps.
3.Install the washing machine
• Remove the protective film from the control panel
(if available on your model).
• Move the appliance without lifting it by the worktop.
• Install the appliance on a solid and level floor
surface, preferably in a corner of the room.
surface, preferably in a corner of the room.
surface, preferably in a corner of the room.
• Make sure that all four feet are stable and resting
Make sure that all four feet are stable and resting
Make sure that all four f
Make sure that all four f
Make sure that all four
Make sure that all four feet are stable and resting
Make sure that all four f
on the floor and then
on the floor and then
on the floor and then check that the washing
machine is perfectly
machine is perfectly leve
machine is perfectly level (use a spirit level).
level (use a spirit level).
• In case of wooden or so-called "floating floors"
In case of wooden or so
In case of wooden or so
(for instance certain parquet or laminate floors),
(for instance certain parq
(for instance certain parq
place the appliance on a 60 x 60 cm sheet of
place the appliance on a
place the appliance on a
plywood at least 3 cm in thickness which is
secured to the floor.
• Make sure that the ventilation openings in the
base of your washing machine (if available on
your model) are not obstructed by a carpet or
other material.
4.Water inlet
• Connect the water inlet hose(s) to the drinking
water supply in accordance with the regulations
of your local water company.
• For models with one inlet valve: cold water
• For models with two inlet valves: cold AND hot
water, or cold water only (see separate
Installation Guide).
• Water tap:
Black process 45.0° 130.0 LPI
using the machine, it is
using the machine, it is
from the control panel
from the control panel
lifting it by the worktop.
lifting it by the worktop.
a solid and level floor
a solid and level floor
feet are stable and resting
eet are stable and resting
check that the washing
check that the washing
l (use a spirit level).
3/4" threaded hose
connector
GB 1
• Keep these Instructions for Use, the Programme
Chart and the Installation Guide; if you pass on the
washing machine to another person, also give him/
her Instructions for Use, Programme Chart and
Installation Guide.
• Water pressure
(flow pressure):
100-1000 kPa (1-10 bar).
000 kPa (1-10 bar).
000 kPa (1-10 bar).
• Use only new hoses to connect the washing
Use only new hoses to connect the washing
Use only new hoses to connect the washing
machine to the water
machine to the water su
machine to the water supply. Used hoses must
supply. Used hoses must
pply. Used hoses must
not be used and should be discarded.
not be used and should be discarded.
not be used and should be discarded.
• For models with hot fill: the hot water inlet
For models with hot
For models with hot f
fill: the hot water inlet
ill: the hot water inlet
temperature must not exceed 60°C.
temperature must not exceed 60°C.
temperature must not exceed 60°C.
5.Drain
• Connect the drain hose to the siphon or hook it
Connect the drain hose to
Connect the drain hose to
over the edge of a sink by means of the "U" bend
over the edge of a sink by means of the "U" bend
over the edge of a sink by means of the "U" bend
supplied.
supplied.
supplied.
• If the washing machine is connected to an
If the washing machine is connected to an
If the washing machine is connected to an
integrated drainage syst
integrated drainage system, ensure the latter is
integrated drainage syst
equipped with a vent to avoid simultaneous
equipped with a vent to avoid simultaneous
equipped with a vent to avoid simultaneous
loading and draining of water (siphoning effect).
loading and draining of water (siphoning effect).
loading and draining of water (siphoning effect).
6.Electrical connection
6.Electrical connection
6.Electrical connection
• Electrical connections must be carried out by a
Electrical connections must be carried out by a
Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer's instructions and current standard
safety regulations.
• Data regarding voltage, power consumption and
protection requirements is given on the inside of
the door.
• The appliance must be connected to the mains by
means of a socket with an earth connection in
accordance with current regulations. The
washing machine must be earthed by law. The
manufacturer declines all liability for damage to
property or injury to persons or animals due to
non-compliance with the directions given above.
• Do not use extension leads or multiple sockets.
• Before any maintenance on the washing machine
disconnect it from the mains supply.
• After installation, access to the mains plug or to
disconnection from mains supply must be
ensured at all times via a double-pole switch.
• Do not operate the washing machine if it has
been damaged during transport. Inform the
After-Sales Service.
• Mains cable replacement is only to be carried out
by After-Sales Service.
• The appliance must only be used in the
household for the prescribed uses.
Minimum housing dimensions:
Width:
600 mm
Height:
850 mm
Depth:
600 mm

Advertisement

loading

  Related Manuals for Whirlpool WWCR-9230

  Summary of Contents for Whirlpool WWCR-9230

  • Page 1: Before Using The Washing Machine

    30106390GB.fm Page 1 Tuesday, February 22, 2011 2:56 PM DEFINITION OF USE This washing machine is exclusively destined to • Keep these Instructions for Use, the Programme wash and spin machine washable laundry in Chart and the Installation Guide; if you pass on the quantities which are usual for private households.
  • Page 2: Precautions And Recommendations

    30106390GB.fm Page 2 Tuesday, February 22, 2011 2:56 PM PRECAUTIONS AND RECOMMENDATIONS 1.Safety instructions to the applicable collection point for the recycling • The washing machine is appropriate for indoor of electrical and electronic equipment. use only. Disposal must be carried out in accordance with local •...
  • Page 3: Description Of The Washing Machine

    30106390GB.fm Page 3 Tuesday, February 22, 2011 2:56 PM DESCRIPTION OF THE WASHING MACHINE Depending on the model: 1. Worktop 2. Control panel 3. Detergent dispenser 4. Service plate (inside the door) Service plate (inside the door) Service plate (inside the door) 5.
  • Page 4: Detergents And Additives

    30106390GB.fm Page 4 Tuesday, February 22, 2011 2:56 PM PREPARATION OF THE WASHING 1.Sort the laundry according to... Stain removal • Type of fabric / care label symbol • Blood, milk, eggs etc. are generally removed by Cottons, mixed fibres, easy care/synthetics, the automatic enzyme phase of the programme.
  • Page 5 30106390GB.fm Page 5 Tuesday, February 22, 2011 2:56 PM Where to put detergent and additives The detergent drawer has three chambers (fig. “A”). Prewash Chamber • Detergent for the prewash Main Wash Chamber • Detergent for the main wash • Stain remover •...
  • Page 6: Draining Residual Water/Cleaning Filter

    30106390GB.fm Page 6 Tuesday, February 22, 2011 2:56 PM DRAINING RESIDUAL WATER/ CLEANING THE FILTER We recommend that you check and clean the filter regularly, at least two or three times a year, especially: • If the “Clean pump” indication lights up.
  • Page 7: Care And Maintenance

    30106390GB.fm Page 7 Tuesday, February 22, 2011 2:56 PM CARE AND MAINTENANCE Appliance exterior and control panel Door seal • Wash down with a soft, damp cloth; if necessary • Dry the door seal after each washing with an use a neutral detergent (non abrasive). Dry with absorbent cotton cloth;...
  • Page 8: Troubleshooting Guide

    30106390GB.fm Page 8 Tuesday, February 22, 2011 2:56 PM TROUBLESHOOTING GUIDE Your washing machine is equipped with various automatic safety functions. These enable faults to be detected in good time and the safety system can react appropriately. These faults are frequently so minor that they can be removed within a few minutes.
  • Page 9 30106390GB.fm Page 9 Tuesday, February 22, 2011 2:56 PM Description of failure indications Failure Description indication Causes lights up Solutions Appliance has no or insufficient water supply. The “Start/Pause” light blinks. Check whether: • Water tap is fully open and water supply pressure is sufficient. •...
  • Page 10 30106390GB.fm Page 10 Tuesday, February 22, 2011 2:56 PM Failure Indication Description indication on display Causes lights up (if available) Solutions from “F03” to “F43” “Electrical module fault” (except “F18” and Push the “Reset” button for at least 3 seconds. “F24”) “F24”...
  • Page 11: After Sales Service

    30106390GB.fm Page 11 Tuesday, February 22, 2011 2:56 PM AFTER-SALES SERVICE Before contacting After-Sales Service: Specify: • The nature of the problem. 1. Try to remedy the problem yourself (see • The washing machine model. “Troubleshooting Guide”). • The service code (number after the word SERVICE). 2.
  • Page 12: Electrical Connection

    30106390GB.fm Page 12 Tuesday, February 22, 2011 2:56 PM ELECTRICAL CONNECTION For Great Britain only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A.