Specifications; Acoustic Output Table; Electromagnetic Compatibility - Mcube CUBEscan BioCon-900S Operator's Manual

9 SPECIFICATIONS

ACOUSTIC OUTPUT TABLE

9.1
WARNING
ALARA principle (As Low As Reasonably Achievable) should be employed for all medical ultrasound
exposure. Users can not adjust the acoustic output energy of the BioCon-900S. The output level is
below than the levels which were referred in AIUM remarks in 1992 and there were no reported
biological effects under the level. However, to minimize exposure, measurements should be kept as
short as possible. Refer to the acoustic output section for more information.
Transducer Model: BioCon-900S Transducer
The values in this table are the maximum readings obtained from each frequency.
Index Label
Global Maximum Index Value
Pr,a
P
Min of [Pα(zs), Ita,α(zs)]]
Assoc z
s
Acoustic z
bp
Parameter z
b
z at max. I
d (z )
eq b
fawf
Dim of Aaprt
t
d
prr
pr at max. Ipi
Other d at max. Ipi
eq
Information Focal
Length
Ipa.3 at MImax
Operating
Control
Conditions

ELECTROMAGNETIC COMPATIBILITY

9.2
Electromagnetic emissions
9.2.1
Guidance Manufacturer's declaration - electromagnetic emissions
The BioCon-900S is intended for use in the electromagnetic environment specified below. The
customer or the user of the BioCon-900S should assure that it is used in such an environment.
Phenomenon
RF Emissions CISPR 11
(MPa)
(mW)
(mW)
pi
(MHz)
X (cm)
Y (cm)
(microsec)
(MPa)
FLx (cm)
FLy (cm)
(W/cm2)
Test level /
requirement
Group 1
TM
CUBEScan BioCon-900S Operator's Manual
MI
scan
Aaprt<=1
0.34 0.62
0.48
0.99
(cm)
(cm)
(cm)
(cm) 2.7
(cm)
2.04 2.04
1.1
1.1
1.22
(Hz) 390
0.61
(cm)
5.5
5.5
7.8
Electromagnetic environment - guidance
The BioCon-900S uses RF energy only for its
Operating Mode: B-mode
TIS TIB
non-scan non-
Aaprt >1 scan
TIC
Page 51