Select Patient Type - Mcube CUBEscan BioCon-900S Operator's Manual

1) Press the Power Button (
2) Only Loading screen (2) appears on the display.
3) Home screen appears when the system is fully loaded at start up.
Turn System off
1) Press the Power Button (
SHUTDOWN MODE
5.2.2
The probe draws little power when it is gone into sleep mode. To preserve battery power, the probe shuts
down the system in approximately 24 hours after going into sleep mode, if there is no activity. However, if
you do not plan to use the probe for more than a week, you should shut the system down completely to
prevent it from discharging completely
Turn System on
1) Press the Power Button (
2) Loading screen (1) appears on the display and Loading screen (2) follows shortly.
3) Home screen appears when the system is fully loaded at start up
Turn System off
1) Press the Power Button(
2) A Shutdown dialog box appears on the Home screen.
3) Ths system shut down shortly after Shutdown screen appears.
Figure 12 Shutdown Dialog Box

SELECT PATIENT TYPE

5.3
BioCon-900S has several patient types. Tap the Patient icon on the Home screen to select the patient type.
1) Male (All other patients)
2) Female patient – Select if you are scanning a female patient. If you select the female patient type
on the Home screen, the BioCon-900S allows you more granularity in chosing an female patient
type on the Information screen. Select female patient by tapping the (1) of Figure 23.
- A female who has not had a hysterectomy (
- A female who has had a hysterectomy (
3) Pediatric patient – Select if you are scanning a child with height less than 47 inches (120cm) and
weight less than 55 lbs. (25kg).
CUBEScan
) shortly to wake the probe from sleep mode.
) shortly twice to go into sleep mode.
) shortly to wake the probe from shutdown mode.
) for 3~4 seconds.
Figure 13 Shutdown Screen
)
TM
BioCon-900S Operator's Manual
)
Page 21