Battery Status - Mcube CUBEscan BioCon-900S Operator's Manual

Tap a Setup Value of the desired setup item.
1)
Tap repeatedly a setup value untile desired setup value.
2)
You can move to other Setup screen (1, 2, 3) by tapping the Previous or Next icon (
3)
Tap the Home icon (
4)
Figure 59 Setup Screen (1)

BATTERY STATUS

6.10
A fully charged battery
A battery about 60% charged
A battery nearly depleted
When the battery is nearly depleted, following dialog box appears asking you to charge the battery.
Figure 62 Dialog box - Needs to be recharged

To conserve battery power, the probe goes into sleep mode by turning off the screen when not in use
for a specified time. You can adjust the time to go into sleep mode in the setup. See the section "7.4
SLEEP MODE SETTINGS". The probe also goes into sleep mode if you press the Power Button(
briefly with power on.

To preserve battery power, the probe goes into shut down mode in approximately 24 hours after going
into sleep mode, if there is no activity. However, if you do not plan to use the probe for more than a
week, you should shut the probe down completely to prevent it from discharging completely.

It takes approximately 6 hours for the discharged battery to fully charge.

Fully charged battery can provide approximately 1,000 normal scans.

Contact your local distributor when the fully charged battery does not allow normal scan for 10min.
) to finish adjusting the setup.
Figure 60 Setup Screen (2)
TM
CUBEScan BioCon-900S Operator's Manual
Figure 61 Setup Screen (3)
A battery about 80% charged.
A battery about 40% charged
Recharge the battery immediately
, )
)
Page 37