Panduit FCE4U Installation Instructions Manual page 8

Opticom rack mount fiber cassette enclosure
Table of Contents

Advertisement

© Panduit Corp. 2010
FOSM Fiber Optic Splice Module Installation
FOSM (12)
capacity
FAPs
(12) capacity
Isometric view showing tray fully
open and tilted down.
(cables omitted for clarity)
For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
FOSM Holder
(Panduit Part No.
FOSMH4U)
Figure 8A
Page 8 of 10
Place FOSM Holder over #10-32 studs on
sliding tray (note orientation). Secure with
#10-32 hex nut. Place first FOSM on top of
FOSM Holder (note orientation). The
remaining FOSMs are stacked on top of each
other and snap in place after termination of
lower tray.
Position FAPs between upright flanges as
shown. Once mounted, fully seat NyLatches
to secure FAPs.
Fully extend tray to ensure proper amount of
slack is used.
Finish splicing in each FOSM before adding or
stacking subsequent FOSMs.
FS012

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FCE4U and is the answer not in the manual?

Table of Contents