Bend Radius Posts - Panduit FCE4U Installation Instructions Manual

Opticom rack mount fiber cassette enclosure
Table of Contents

Advertisement

© Panduit Corp. 2010
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS

Bend Radius Posts

in open position
Figure 9
Figure 10
Figure 10A
www.panduit.com
Page 10 of 10
Re-install front and rear door assemblies if
removed during fiber installation.
Attach Laser Warning Label and Caution Label
where they are clearly visible.
Rotate the Bend Radius Posts to the open
position on each end of the patch field to allow
room to route patch cords under the tabs to the
cable manager.
Plug fiber connector into FAP adapter. Route
patch cords down to fiber manager base, under
fiber manager fingers and Bend Radius Posts to
cable manager.
After all patch cords have been routed to the cable
manager, rotate Bend Radius Posts back to the
closed position to contain the patch cords within
the fiber manager. Tighten the connection of the
Bend Radius Posts to the enclosure by securing
the hex nut at the rear of the fiber manager and
tightening the Bend Radius bolt with a Phillips
head screwdriver.
E-mail:
cs@panduit.com
Fax:
(708) 444-6448
FS012

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FCE4U and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents