Relay Menus And Display - Siemens 7SR18 Solkor Manual

7SR18 Configuration Guide
Section 1: Introduction

1.1 Relay Menus And Display

All relay fascias contain the same access keys although the fascias may differ in appearance from
model to model. The basic menu structure is also the same in all products and consists of four
main menus, these being,
Settings Mode - allows the user to view and (if allowed via the settings mode password) change settings in
the relay.
Instruments Mode - allows the user to view the relay meters e.g. current, etc.
Fault Data Mode - allows the user to view the type and data of any fault that the relay has detected.
Control Mode - allows the user to control external plant under the relays control for example the CB (if
allowed via the control mode password)
The menus can be viewed via the LCD by pressing the access keys as below,
Figure 1.1-1 Menu Navigation
Pressing CANCEL returns to the Identifier screen.
LCD Contrast
To change the contrast on the LCD insert a flat nosed screwdriver into the screwhead below the contrast
symbol, turning the screwhead left or right decreases and increases the contrast of the LCD.
Figure 1.1-2 Contrast symbol
Unrestricted Page 4 of 12 © 2015 Siemens Protection Devices Limited