Configuration Setting Table - wtw LF 170 Operating Instructions Manual

LF 170
General operating
instructions
ba54104e09 11/2010

4.4.2 Configuration setting table

The starting point for the settings is the start display of the configuration
level (see section 4.4.1):
C o
Operation:
All settings of the following setting table are run through step by
step.
Select the desired value from the selection in each case with
<UP><DOWN> and confirm this with <ENTER>. After that you
reach the next setting.
Certain settings or choices are only available with specific
instrument variants or depend on other preceding configuration
settings. Settings that are not available will be skipped.
After running through all the settings you again reach the starting
point of the configuration level. From here change to the operating
level with <M> or <ESC> or go to the parameterization level with
<UP><DOWN>.
In view mode you can change to the operating level from any point
with <M>.
Swap to the first setting with
<ENTER>.
Operation
89