Entering Energy Saver Mode - Savin 3799 Operating Instructions Manual

Note
❒ You can still send fax messages stored in memory while the machine is in En-
ergy Saver Mode.
❒ Even in Energy Saving Standby mode, indicators that blink or light during
communication or reception still work. When the Substitute Reception, Mem-
ory Lock or Confidential message indicator lights, exit Energy Saver Mode
and take appropriate action.
❒ You can specify High Temperature Standby mode in combination with either
Energy Saver Standby mode or Fax Standby mode. If High Temperature
Standby mode is turned on, the machine starts a new print job in less time
than the wait time described in the table above, provided it is initiated within
the time specified with User Parameters (switch 31 bits 7,6) after the previous
print job is complete. You can make necessary settings with User Parameters.
See p.178 "User Parameters" (switch 05 bit 3).
❒ You can specify the duration of time before the machine exits High Temper-
ature Standby mode with User Parameters. See p.178 "User Parameters"
(switch 31 bits 7,6).
❒ While the Night Timer is activated, the machine stays in the Energy Saver
Standby mode. If a fax message comes in while the heater is turned off, it is
stored in the machine's memory (Substitute Reception), and printed after the
specified time is reached. See p.176 "Night Timer".

Entering Energy Saver Mode

The machine enters Energy Saver Mode when:
• Nobody uses the machine for about 5 minutes.
• The user holds down the { { { { Clear Modes/Energy Saver} } } } key for about 2 seconds.
Note
❒ If you wish to change the five minute period to one or three minutes, or if you
do not want your machine to enter the Energy Saver Mode automatically,
please contact your service representative.
- - - - When the machine does not enter Energy Saver Mode
The machine does not enter Energy Saver Mode when:
• The optional Handset is not placed correctly
• The main paper tray is not loaded into the machine
• Either the ADF unit, ADF cover or the side cover is open.
• An original is jammed
• The machine is out of order
• There is no paper loaded into either the main paper tray or the optional Paper
Tray Unit
Specifications
10
301