G3 Digital Line - Savin 3799 Operating Instructions Manual

Key Operator Settings
C Press [OK].
Note
❒ If you are making settings for
the "G 3–1 A n a lo g L in e ,"
change the setting for the
standard G3 line to PABX
with User Parameters after
registering the PSTN Access
Number. See p.178 "User Pa-
rameters" (switch 13 bits 1,0).
❒ If you are making settings for
the "G 3–2 A n a lo g L in e ,"
change the setting for the sec-
ond G3 line to PABX with
User Parameters after regis-
t e r i n g t h e P S T N A c c e s s
Number. See p.178 "User Pa-
rameters" (switch 13 bits 3,2).
G G G G
Press [PrevMenu] four times.
H H H H
Press [Exit] to return to the stand-
by mode.
7

G3 Digital Line

This function requires the optional ISDN
Unit.
The following settings are available
for G3 communications over ISDN:
• Own Fax Number 1
E nter the n umber of th e line
(PSTN) the machine is connected
to.
• SPID (Own Fax Number 2)
Enter the second fax number if you
are using two numbers for one
line.
• Sub-address
See p.82 "Sub-address".
• Own Fax Number (CSI) (maxi-
mum 20 characters)
Enter Own Fax Number (Called
Station Identification) that is trans-
ferred to the other party during
transmission or reception.
192
Note
❒ Before storing the sub-address,
store the Sub-address function in a
User Function key. See p.154 "User
Function Keys".
❒ Own Fax Number (CSI) is an inter-
national identification number
that is transferred to the other par-
ty during transmission or recep-
tion. This information appears on
the display of the other party's fax
machine and is printed on their
lists and reports. The Own Fax
Number (CSI) feature works with
other manufacturer's fax machines
that support this feature.
❒ After registering the Own Fax
Number 1 or 2, you can make set-
tings so that the machine does not
respond to incoming faxes that do
not send their Own Fax Numbers
with User Parameters. See p.178
"User Parameters" (switch 13 bit
5).
Reference
p.89 "Selecting the Line"
A A A A
Press the { { { { User Tools} } } } key.
B B B B
Enter the code for "Key Op.
Tools" with the number keys.
Then press the { { { { q q } } } } key.
q q