Table of Contents
Advertisement
Fig. 4-26. Rotate the Lower Cutter into 2:00
Position
Fig. 4-27. Reinstall Knurled Drive Roller
Edge Reinforcer Issue 1
Step: 11. Before reassembling the knurled drive
roller, rotate the lower cutting shaft so
that the flat is in the 2:00 position.
Step: 12.Replace the knurled drive roller and set
screw.
Note !
It is very important to leave a slight
space between the knurled roller and
the lower, cut- off assembly (approx.
1/64").
If this is not done, the assembly will
tend to bind at certain points and
cause an erratic cut.
4 Maintenance
4- -15
Advertisement
Table of Contents
