Adjustment Of The Trip Switch 3 - Scott Edge Reinforcer Instruction Manual

Fig. 3-44. Trip Switch Lever
Fig. 3-45. Loosen Mounting Screws
Edge Reinforcer Issue 1
3.3.13 Adjustment of the Trip Switch
The trip switch (A) is located next to the ball holder.
Symptoms indicating that trip switch is broken or
needs adjustment:
LEVER STAYS DOWN -- If broken and the switch
lever stays down, the machine will not stop each
A
time a sheet goes through. Machine runs
continuously.
SHEETS STOP TOO QUICKLY -- The switch
needs adjustment. When this happens, the sheets
will overlap at times and jam machine. This is
caused by the last sheet stopping before the switch
lever can come up, overlapping the next fed sheet.
FIRST SHEET STOPS TOO LATE -- The switch
needs adjustment. When this happens, there will
be "tails" of tape extending from sheet. This is a
result of the second sheet not catching up with the
first sheet before it gets under the applying roller.
Step: 1. Loosen screws in the switch mounting
Step: 2. Move the mounting plate (which raises
Step: 3. Tighten the screws in the switch
plate.
the switch lever height) so that the switch
lever is extended approximately 1/4"--1/2"
above the sheet. The switch lever should
not be any higher than the "11:00"
position.
mounting plate.
3 Operation
3- -23