Table of Contents
Advertisement
Fig. 3-31. Spacer Finger Should Be Horizontal
and Pointed Toward Front of Machine
Fig. 3-32. Rotate the Cut Off Guide Finger
Above Table
Fig. 3-33. Remove Table Screw
Edge Reinforcer Issue 1
A
B
Step: 7. With your hand, push the spacer finger
(A) so that it is in a horizontal position
(parallel to the table) and pointing toward
the front of the machine.
NOTE!
There is a "flat" on the hub which
provides the clearance needed to lift
off table.
Step: 8. Make sure that the cut--off guide finger
(B) is NOT down between the slot in the
table (this is the curved finger).
It must be above the slot.
If it is down in the slot, it will hook the
table and could damage the table by
making a burr or hurt the finger by being
bumped.
Step: 9. Remove the table mounting screw.
3 Operation
3- -17
Advertisement
Table of Contents
