To Remove The Table 3 - Scott Edge Reinforcer Instruction Manual

3 Operation
3.3.8 To Remove the Table
Occasionally is will be necessary to remove the table to clear tape that has wrapped around lower pressure
roller.
CAUTION: The table is a precision part of the machine and must be handled with extreme care. The
operator must be very careful not to drop it or damage it in any way. even small dents or burrs on the
top surface may tend to snag the sheets as they go through and can cause operating difficulties.
Fig. 3-29. Jog Last Sheets Out of Machine and
Turn Feeder and Drive Off
Fig. 3-30. Remove the Cut Off Package Guard
3- -16
To remove the table, do the following:
Step: 1. Cut the tape so that it is free of the roll.
Step: 2. Remove paper from the feeding area.
Step: 3. Jog the last sheets out of the machine.
Step: 4. Shut off the sheet Feed.
Step: 5. Turn the Drive switch to OFF.
Step: 6. Remove the Cut Off Package guard.
Edge Reinforcer Issue 1